If this is the first time you've seen this stop error screen, restart your computer. The problem seems to be caused by the following file: nv4_disp

My poblem is that when I awaken my PC from standby mode, it takes about a minute to come on and the first thing I see is a blue screen that reads (only shows for about 5 second, I took photo)Ī problem has been detected and windows has been shut down to prevent damage to your computer. Now my monitor works and the simulator works. Maybe it just needed the driver installed but I remembered the gut saying that the driver could cause problems too so I removed it again and took it to the pros. They got it working even though my settings are the same as when I started, 1024 x 768 pixels and 60 Hertz. After trying several settings and getting nowhere, I took it back to the shop. Just a breif message that it's out of frequency range but now it says to lower resolution. I don't have this option but I set it to 75 Hertz. The frequency was already at it's lowest setting (60 Hertz) and a call to the place of purchase said the lower frequenct is for an LCD, my VGA monitor needs 73 Hertz. I didn't want to wait so I did the install but couldn't get a picture, just a quick message that my monitor was out of frequency range and to lower the frequency. I had to get an AGP card and got the GeForce 6200 LE. I got ClearView but it needed a 3D graphics card. I downloaded the files I wanted to keep to an external hard drive but my FMS (flight model simulator) didn't make it so I had to get another simulator. I had the hard drive cleaned on my old HP Compaq Presario 6000 since I was down to less than 50% free space (33GB)

Bfg geforce 6200 driver